EN
- Overview
- Related Products
| Model | NPN open collector | BPB-CA2M | BPB-CB2M |
| PNP open collector | BPB-CD2M | BPB-CE2M | |
| Sensing type | Diffuse reflective | ||
| Sensing Range | 2m (non-glossy white paper 200x200mm | ||
| Sensin target | Translucent, opaque materials | ||
| Hysteresis | Max.20% at Sensing Range | ||
| Response time | Max.1ms | ||
| Power supply | 12 - 24 VDC ± 10 % (Ripple P-P:Max.10%) | ||
| Current consumption | Max. 15mA (max. 30mA when the output is ON) | ||
| Light source | Infrared LED(850nm) | ||
| Sensitivity adjustment | Sensitivity adjuster | ||
| Operation mode | Light ON | Dark ON | |
| Control output | NPN or PNP open collector output | ||
| Load voltage:Max, 26.4VDC, Load current:Max, 100mA Residual voltage -NPN: max.1VDC PNP: min.2.5VDC | |||
| Protection circuit | Reverse polarity protection circuit, output short overcurrent protection circuit | ||
| Indicator | Operation indicator: red LED Stability indicator: orange LED (light on), green LED (dark on) | ||
| Insulation resistance | Min.20MΩ (at 500VDC megger ) | ||
| Noise immunity | ±240V the square wave noise (pulse width:1㎲)by the noise simulator | ||
| Dielectric strength | 1000VAC 50/60Hz for 1minute | ||
| Vibration | 1.5mm amplitude at frequency of 10 ~ 55Hz (for 1 min) in each X, Y,Z direction for 2 hours | ||
| Shock | 100 m/s2(10G)in X,Y,Z directions for 3 times | ||
| Environ- ment |
Ambient illumination | Sunlight :Max.11,000lx , Incandescent lamp:Max.3,000lx (receiving illumination) | |
| Ambient temperature | -20~+55℃ ,Storage:-25~+70℃ | ||
| Ambient humidity | 35~85%RH, Storage:35~85%RH | ||
| Material | Case: acrylonitrile butadiene styrene, sensing part: polycarbonate, indicator: polycarbonate, adjuster: lXEF |
||
| Protection | IP64(IEC standard) | ||
| Cable | Φ3.0mm, 3-wire, Length :2m | ||
| Accessory | Adjuster driver | ||
